Includes 3mm countersunk washers and screws
Battery not included - recommend PTK-5183 (here)
Currently not directly compatible with 22T 4.0 conversions
This 3D printed prototype part is designed to allow for a smaller battery pack to be mounted to the rear ball stud mount of an XT2 or T6.1, T6.2, or T6.4.
The pictured ProTek 500mah LiFe is significantly lighter than even the lightweight 1600mah LiPo.
Battery not included - recommend PTK-5183 (here)
Currently not directly compatible with 22T 4.0 conversions
This 3D printed prototype part is designed to allow for a smaller battery pack to be mounted to the rear ball stud mount of an XT2 or T6.1, T6.2, or T6.4.
The pictured ProTek 500mah LiFe is significantly lighter than even the lightweight 1600mah LiPo.
- Less weight overall
- Shifts weight bias towards the rear
- Enough runtime for 20 minute mains
Team Associated T6.1 or T6.2 donor truck
Flywheel collet (ASC81371 recommended)
.12 Engine w/ SG Crankshaft (slide or rotary carb)
Tuned pipe and manifold
Throttle servo
Standard or Low profile steering servo
On/Off switch
Receiver battery pack
12mm strapping tape for receiver battery
Transmitter/receiver
Fuel line
Glow igniter
Battery charger
Air filter oil
Fuel bottle
Starter box - LRP Ongaro or AE box with adapter plate recommended
Starter box battery
Fuel
